Updated for Version 1.3.2
Having created a Building you may want to adjust the form by changing the contour of the different Building Faces.
The process to change a Contour uses the same sketch based approach as the initial building creation process.
To create/edit Faces you need to switch to the Edit Facades Tool
This changes the 3d view into a simplified view of the Building allowing you to easily tap on the face to edit.
Once a face is selected, the 2d view changes to show you the face section.
To edit the contour/profile, tap the Edit button in the Edit Toolbar
Using the sketch methods you are familiar with, sketch and erase strokes as required to define the contour you want for the Face.
To apply the changes click the Accept button in the Edit Toolbar
The Face is updated in the 3d Model
Once you switch back to the Main Toolbar, the primary model view is displayed again. All building areas are automatically updated based on the effect of this new face contour.
Multiple Face Editing
While you might only be interested in the specific face you selected, you are also able to edit other faces that are perpendicular to the current section. The following Vector based editing view shows you a number of faces available for editing:
In the example above a single face was selected in the 3d view and therefore all faces were individually editable.
However, in some cases you want to edit the entire face as a single entity. In order to do this you need to double-tap one of the faces. A double-tap will select all faces that can be edited as if they were a single continuous face:
You can see in this instance the 3d shows all faces selected, and the section view shows a single editing contour of the right-hand side.
Edit this contour and all faces are updated:
